Bauknecht GSIK 6528 Installation And Maintenance Instructions Manual
Bauknecht GSIK 6528 Installation And Maintenance Instructions Manual

Bauknecht GSIK 6528 Installation And Maintenance Instructions Manual

Advertisement

GB
GSIK 6528
Programme selector
START button
The indicator lights up during operation, flashes when a fault
occurs, and goes off at the end of the programme.
START button RESET function:
Press this button for at least 2 seconds to cancel a started
programme and selected extra functions. The main fault
indications (repeated flashing of the START indicator) can be
cancelled by RESETTING. Also refer to section 5 "What to do, in
case of...".
Rinse aid level indicator and salt level indicator
They light up when rinse aid or salt need to be added.
Add just before starting a wash cycle.
Fault indication and wash time display
In normal operation it indicates the remaining time (h:mm),
whereas with "Delayed start" selected it indicates the time
remaining until programme start (hh).
With indication "F ..", refer to section 5 "What to do, in case of ...".
Delayed Start button
Press the button (repeatedly) to delay the start of the programme.
Adjustable from 1 to 24 hours. With each press of the button, the
delayed start indicator increases by one hour and after 24 restarts
from 00. Then press the START button. The dishwasher will start
after the set time.
P
Programmes
1
Auto Sensor
2
Pre-Rinse
3
Quickwash
4
Bio Normal
5
Intensive
1)
Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads, extra
functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness and power supply voltage.
2)
Energy label programme in compliance with EN 50242. - Information for Test Laboratories: for more detailed information on the EN comparison
test and other tests, contact the following address: "nk_customer@whirlpool.com".
3)
The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with. Standard NF EN 13697 - November 2001.
Before using the dishwasher, read the
installation and maintenance instructions carefully!
1. OVERVIEW
Table 1.1.

Table of programmes

Selectable
extra
functions
50-65°C
cold
40°C
2)
50°C
70°C
Detergent setting at first startup and when using a different type of detergent
1. Select the third programme in the relevant table.
2. Press the START button for about 7 sec. to change the display.
3. Using the START button, set the required detergent:
The display shows: 2 -1 = 2 in 1, 3 -1 = 3 in 1, 4 -1 = other combined action
detergents (in this way, the rinse aid and/or salt indicator is deactivated).
The display shows OFF = Powder detergent (factory setting)
(rinse aid and salt indicator activated).
4. Switch the appliance off and then on again. The selected detergent will be
displayed for approx. 3 sec.
Half Load/Multizone button
Only load the top rack or bottom rack.
Press once = wash top rack (the indicator/symbol lights up)
Press twice = wash bottom rack (the indicator/symbol lights up)
Press 3 times = Off (Half load/Multizone deactivated).
When washing without the top rack, press the "Half load" (i.e. "wash
bottom rack") button twice; the corresponding indicator/symbol
lights up.
3)
Antibacterial rinse
This function activates an antibacterial rinse ensuring a further
reduction of bacteria. Press the button to activate or deactivate
this function and the appropriate programmes are indicated with
the corresponding symbol in table 1.1.
The dishwasher door must remain closed for the entire duration
of the programme, to ensure the reduction of bacteria. If the door
is opened the indicator starts flashing.
On / Off Button
Detergent
dispenser
Loading instructions
large
Recommended programme for
daily use, with dry food residuals
X
(e.g. EN 50242).
Dishes to be washed later.
Slightly dirty dishes, without
X
dry residuals.
Normally dirty dishes.
X
Energy-saving programme.
Recommended programme for
very dirty dishes, particularly
X
suitable for pots and pans.
1)
Consumption
small
Litres
kWh
Minutes
X
11-16 1.10-1.50 100-130 ±
1)
4.0
0.03
14 ±
1)
10.0
0.65
30 ±
X
12.0
1.05
165 ±
X
14.0
1.55
155 ±
5019 496 01085
1)
1)
1)
1

Advertisement

Table of Contents
loading

Summary of Contents for Bauknecht GSIK 6528

  • Page 1: Detergent Dispenser

    Before using the dishwasher, read the installation and maintenance instructions carefully! GSIK 6528 1. OVERVIEW Detergent setting at first startup and when using a different type of detergent 1. Select the third programme in the relevant table. 2. Press the START button for about 7 sec. to change the display.
  • Page 2 2. QUICK REFERENCE GUIDE Detailed instructions are given on the following pages; also see section “5. What to do, in case of...” 1. Switch on the Press the ON/OFF button. appliance Press the button “Select programme” or the programme selector to display the 2.
  • Page 3: How To Use The Appliance

    3. HOW TO USE THE APPLIANCE PROGRAMME SELECTION Press the button “Select programme” or the programme selector to display the selected programme. The appliance must be switched on. If required, select possible options. The corresponding indicator lights up. The correct programme and the selectable functions are given in table 1.1 on page 1. Programme times stated in the table were obtained under normal conditions and may vary depending on conditions.
  • Page 4 3. HOW TO USE THE APPLIANCE c. How to adjust the rinse aid dosage regulator The rinse aid dosage can be adjusted to the detergent used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4). Press the button 2 to open the cover.
  • Page 5: How To Load The Racks

    3. HOW TO USE THE APPLIANCE HOW TO LOAD THE RACKS UPPER RACK - depending on the model Multifunction support A Three possible positions for long utensils, cups and glasses. Crockery holder B In horizontal position: cups/long utensils, in raised position for plates and stemware.
  • Page 6: Precautions And General Recommendations

    4. PRECAUTIONS AND GENERAL RECOMMENDATIONS 1. Packing The packaging materials are 100% recyclable and marked with the recycling symbol. 2. Removing the packaging and inspecting the contents After unpacking, make sure that the dishwasher is undamaged and that the door closes correctly. If in doubt, contact a qualified technician or your local retailer.
  • Page 7: What To Do If

    5. WHAT TO DO IF... If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance...
  • Page 8 5. WHAT TO DO IF... Crockery and cutlery ... Possible causes/solutions ...are not perfectly clean/have food In the event of frequent use of low temperature programmes residues (50°C or lower) (if available), every now and again select a higher temperature programme The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see the instructions in “Maintenance and installation”).

Table of Contents