Table of Contents
Advertisement
3.8
Transport safety
a) Be aware of your surroundings and machine operating level. Do not side hill, do not run on steep incline,
this could cause machine to tip over.
b) The weight of 350S is 415 kg. Use a crane or lift when transporting the machine, use the lifting eye of the
machine.
c) Before every use check the lifting eyes/lugs and welds for:
deformation, damages, cracks, corrosion and wear.
d) When lifting the machine from the ground, always use the lowest lifting speed. The cables must first be
tensioned at this speed; they must not be slack when the machine is lifted from the ground.
e) During hoisting make sure to be at a safe distance from the machine with the most optimal view on the
machine and working environment.
f)
Never stand directly below the machine.
g) When transporting the machine do so in such a manner that damage due to the effects of the use of force
or incorrect loading and unloading is avoided.
h) The lifting eye can also be used to fasten the machine on a pallet or during transport.
i)
Always drive backwards when driving up to a ramp or grade, and forwards when driving of the ramp.
j)
Chock wheels for transport and keep control handle in neutral position.
k) Don't leave the machine unsecured on jobsites.
l)
Park the machine always on a flat horizontal and levelled surface.
m) Remove the abrasive from the machine before transport.
n) Make sure the electrical cable and dust hose are disconnected before transport.
o) Store the cleaned and dry machine in a humid free room. Protect the electrical motor from moisture, heat
dust and shocks.
p) Never use the machine for lifting persons or items.
q) Only lift the machine from the lifting eye, as shown in the picture below.
8
Advertisement
Table of Contents
