Download Print this page

Introduction; Safety; Operation - Husqvarna AX 36 Operator's Manual

Hide thumbs

Advertisement

Cancer
Birth defects
Skin inflammation
Use correct equipment to decrease the quantity of
dust and fumes in the air and to decrease dust on
work equipment, surfaces, clothing and body parts.
Examples of controls are dust collection systems
and water sprays to bind dust. Decrease dust at the
source where possible. Make sure that the
equipment is correctly installed and used and that
regular maintenance is done.
Use approved respiratory protection. Make sure that
the respiratory protection is applicable for the
dangerous materials in the work area.
Make sure that the airflow is sufficient in the work
area.
If it is possible, point the exhaust of the product
where it cannot cause dust to go into the air.
Noise safety
WARNING: Read the warning instructions
that follow before you use the product.
High noise levels and long-term exposure to noise
can cause noise-induced hearing loss.
To keep the noise level to a minimum, do
maintenance on and operate the product as given in
the operator's manual.
Use approved hearing protection while you operate
the product.
Listen for warning signals and voices when you use
hearing protection. Remove the hearing protection
when the product is stopped, unless hearing
protection is necessary for the noise level in the work
area.
Personal protective equipment
WARNING: Read the warning instructions
that follow before you use the product.
Always use approved personal protective equipment
when you operate the product. Personal protective
equipment cannot fully prevent injury but it

Introduction

WARNING: Read and understand the safety
chapter before you use the product.
To start and stop the product
1. Connect the product to a power source.
6
decreases the degree of injury if an accident does
occur. Let your dealer help you select the correct
personal protective equipment.
Regularly do a check of the condition of the personal
protective equipment.
Use an approved protective helmet.
Use approved hearing protection.
Use approved respiratory protection.
Use approved eye protection with side protection.
Use protective gloves.
Use boots with steel toe-cap and non-slip sole.
Use approved work clothing or equivalent close-
fitting clothing that has long sleeves and long legs.
Safety instructions for maintenance
WARNING: Read the warning instructions
that follow before you use the product.
If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
Clean the product to remove dangerous material
before you do the maintenance.
Disconnect the product from the power source
before you do the maintenance.
Do not do modifications to the product. Modifications
that are not approved by the manufacturer can
cause serious injury or death.
Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
Replace damaged, worn or broken parts.
Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
Let an approved service agent do servicing on the
product regularly.

Operation

2. Make sure that the ON/OFF switch is set to "OFF".
3. Start the power source.
4. Set the ON/OFF switch to "ON" to start the product.
5. Set the ON/OFF switch to "OFF" to stop the product.
6. Stop the power source.
1006 - 002 - 27.03.2020

Advertisement

loading

  Related Manuals for Husqvarna AX 36

This manual is also suitable for:

Ax 40Ax 48Ax 56Ax 65Ax 90