Changing The Liners - Husqvarna BLASTRAC EBE 350S Operating Instructions Manual

Store the cleaned and dry machine in a dry and humid free room. Protect the electrical motors from moisture,
heat, dust and shocks.
All repair work must to be done by qualified personnel, this to guarantee a safe and reliable machine.
Any guarantee on the machine is expired when:
Non original parts have been used

Repair work is not done by qualified personnel

Changes, add on's or conversions are undertaken without written permission

Screws, bolts etc. that have been removed must be replaced with those of the same quality, strength, material
and design.
Do not weld, flame cut or perform grinding works on or near the machine. Danger of fire or explosion exists!
Provide adequate ventilation when working in a confided space.
Secure the maintenance area if necessary.
Clean the machine every day with air and non-aggressive materials. Never use a high
6.1

Changing the liners


Loosen the press bolts of the top liner and remove the cover and top liner.

Hammer out the side liners from the blast housing. Take them out at the top of the housing.
To mount the liners, keep on the following sequence:

Replace all worn items.

Clean the liners and the inside of the blast housing thoroughly.

Re-assembly the machine in reverse order, using kit between the top liner and the side liners, and
between the top liner and the front and rear plates of the blast housing.

Make sure that the top liner sits close at the edges of the side liners.
pressure water cleaner to clean the machine.
1 Top liner cover
2 Top liner
3
Side liner
24