Heat-Sink-And-Fan Assembly - Lenovo ThinkStation P2 Tower Hardware Maintenance Manual

Replacement procedure
Note: The rear fan is attached to the chassis by four rubber mounts. Stretch the tips of the rubber mounts
and gently pull the rear fan assembly out of the chassis.
Note: Align the rubber mounts with the corresponding holes in the chassis and push the rubber mounts
through the holes. Rotate and pull the tips of the rubber mounts until the rear fan assembly is secured.

Heat-sink-and-fan assembly

Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
. 85
Chapter 7 Hardware removal and installation