• "Computer cover" on page 54
• "2.5-inch primary hard disk drive, bracket, and cage" on page 58
• "M.2 solid-state drive and heat sink" on page 78
Replacement procedure
Front fan
Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
For access, do the following:
1. Remove these parts in order, if any:
• "Computer cover" on page 54
• "Front bezel" on page 56
2. Disconnect the front fan cable from the front fan connector on the system board.
Note: The front fan is attached to the chassis by four rubber mounts. Stretch the tips of the rubber mounts
and gently pull the front fan assembly out of the chassis.
.
Chapter 7
Hardware removal and installation
83