User And Maintenance Manual; Use; Getting Started; Internal Layout (Positioning, Adjusting And Removing Components) - Bertazzoni RLD60S5FPNS User And Maintenance Manual

USE

GETTING STARTED

Before using the appliance, make sure that all preparations
have been made according to the instructions provided in
the section SAFETY INFORMATION in the Installation
Manual.
• Clean the interior of the refrigerator as recommended in
the CLEANING AND CARE section. Before you turn on
the refrigerator, make sure that the interior is dry.
• Plug the refrigerator into a grounded socket. The interior
lighting comes on when the refrigerator door is opened.
• Run the refrigerator for 6 hours before placing any food
in it and do not open its door unless it is necessary.
NOTE
You will hear a noise when the compressor
starts up. The liquids and gases sealed
within the refrigeration system may also
cause noise, even if the compressor is not
running. This is quite normal.
NOTE
The front edges of the refrigerator may feel
warm. This is normal. These areas are
designed to be warm in order to prevent
condensation.
During operation, you may hear some absolutely normal
noises:
• Buzzing: The refrigerator is running. The fan of the air
recirculation system is running.
• Bubbling, humming or gurgling noises: refrigerant is
flowing through the pipes.
• Clicking: motor is turning on or off. Solenoid valve on
water connection opening/closing.
• Rumbling: ice cubes are falling into the ice bin.
The unit is powered by two independent compressors. It is
therefore normal that one of the two compressors is always
running.
12
INTERNAL LAYOUT (POSITIONING,
ADJUSTING AND REMOVING COMPONENTS)
DOOR BINS
To remove a door bin, hold it from the bottom, lift it and slide
it out. Please see the figure.
To adjust the height of a door bin, press and hold the
buttons at the right and left sides to adjust the bin to the
desired height without having to remove it. To remove the
adjustable door bin, press and hold the buttons, lift the bin
completely and pull it towards yourself. To reinstall the door
bin, position it in its place on the door and press the buttons
to slide it downwards. Please see the figure.
Fig. 2
Fig. 3