Panasonic DOUBLEFEATURE PV-D4763S Operating Instructions Manual page 55

Set t henumber ofspeakers connected tothereceiver
(amplifier, decoder.) (See pp. 1 4, 1 5.)
Do steps 1-3 on page 54.
Press Ay
to select "SPEAKER
SETUP," and
press SETto display
SPEAKER SETUP
screen.
;_'E_ER _op Press A_"
to select "SPEAKER
OUTPUT,"
and
press SET repeatedly.
(See below.)
• SPEAKER OUTPUT
MULTI-CHANNEL: (Factory preset)
Use this setting when 3 or more speakers are
connected. In this case, it is necessary to set
[SPEAKER SIZE], [OUTPUT BALANCE], and
[DELAY TIME],
2-CHANNEL:
When 2 speakers are connected, it is not
necessary to set [SPEAKER SIZE], [OUTPUT
BALANCE], and [DELAY TIME] (these setting
menu are net displayed.)
times to exit.
Press ACTlON three
c_) _ o
ODODOD
(2D_CD
AC_ON
SELECT
--AV<,
_SET
Speaker frequency properties and the existence of speakers is set,
Do steps 1~2 of"Speaker Output Setup" above.
Press A_'
to select "SPEAKER SIZE," and press SET
to display SPEAKER SIZE screen.
Press At'
to select an item, and press SET
repeatedly. (See below table.)
Menu item
FRONT
CENTER
SURROUND
SUBWOOFER
times to exit,
Press ACTlON four
Setting
LARGE(factory preset)
SMALL
LARGE(factory preset)
SMALL
NONE
LARGE(factory preset)
SMALL
NONE
ON(factory preset)
OFF
Remark
When the front speakers (R/L) supports low-frequency (under 100 Hz) reproduction
SeIect when the front speakers (R/L) does not support low-frequency reproduction *_
When the center speaker supports low-frequency {under 1 O0 Hz) reproduction
Select when the center speaker does not support low-frequency reproduction
If there is no center speaker
When the surround speakers (R/L) supports Iow4requency (under 100 Hz) reproduction
Select when the surround speakers (R/L) does not support low4requency reproduction.
If there is no surround speaker
If there is a subwoofer
If there is no subwoofer speaker **
**If SUBWOOFER is set to "OFF,"
the front speakers are set to
"LARGE" automatically. 55