Panasonic DOUBLEFEATURE PV-D4763S Operating Instructions Manual page 54

_,B_ ram
Select the d{gital output to be output from the optical
digita( audio output connector of DECK.
Press ACTION*
to display DVD MAIN MENU.
,%'_,%_°°_ ,_u_,, ...... "AUDIO OUTPUT,"
I/A_ NTAL LOCK V_ B _ arid
s_c_ .. press SET
_E_ SET
E_O _o_o_ to display screen.
-- ,uo,oo_T_,u--_--" Press &V
_&_}/y Dig ,_1 8qs,ream#itsElea m
to select an item,
press SET
s_s_L_c__T repeatedly for
_"_ *°'°" output, (See below.)
• "LPCM (DVD)" selections
OFF: Linear PCM of less than 48 kHz/16 bit is
output. When playing DVDs recorded in linear
PCM of over 48 kHz/20 bit, no digital audio is
output. (Factory preset)
PCM: When playing DVDS recorded in linear PCM of
48 kHzJ20 bit/24 bit or more, digital audio
converted to 44.t kHTJ16 b_l or 4.8 kH2J16 b}t is
oatput.
(Digital output of PCM audio is restricted to
48 kHzJ16 bit or below for copyright protection.)
• "Dolby Digital"selections
Bitstream: Dotby Digital bitstream (1 ch - 5.1 ch) is
output. (Factory preset)
PCM: When you have connected a amplifier that
doesn't have a built-in Dolby Digital decoder.
•"dts" selections
Bitstream: DTS bitstream is output. (Factory preset)
PCM: When you have connected a amplifier that
doesn't have a bui|t-in DTS decoder.
• "DRC (Dynamic Range Compression)"
selections
OFF: Normal audio range is selected. (Factory preset)
ON: For dynamic sound even at tow volume, this is
useful for late-night listening. [Dolby Digital
DVDs only].
• SPEAKER SETUP
See pages 55, 56, 57.
Press ACTION to redisplay DVD MAIN
MENU and go to step 2 to setup another
item.
Or, press ACTION twice to exit,
54
_P Ready Checklist
[_ DECK is in DVD mode, press DVD,
Type of amp|ifier _' _,,_,,._'a_
_nn_.e;t_a_ + + 4No amplitieris connected
without DolbyOJgital/DTS
decoder
AVamplifier including
Oolby Digital decoder
AVampli_erincluding
• Make settings according to amplifier
connected to optical audio output as shown
in above table.
"1 When connecting an amplifier (with an
opt)ca) digital input connector) which does
not contain the Dolby Digital or DTS
decoder, be sure to select "PCM".
If "Bitstream" is selected, starting DVD play
may cause such a high level of noise as to
be harmful to your ears and damage the
speakers.
*2 When a DTS decoder is connected, please
select "Bitstream" in "dis'.