Table of Contents
Advertisement
Level 1 and 2 Service Manual
6881039B15
2.
Locate the 6 screws holding the front housing to the rear housing. See
Figure 10.
Push the battery latch in the direction of the arrow to expose the 2 bottom housing
screws as shown in Figure 10.
BATTERY
LATCH
REAR HOUSING
DISASSEMBLY
TOOL
Figure 10. Removing the Rear Housing
3.
Using the Torx driver with a long T5 bit, remove the 6 screws and set aside for
reuse.
4.
Using the flat end of the disassembly tool, carefully disengage the catches on
the top and both sides of the housing, then separate the rear housing from the
front housing.
5.
Lift the rear housing from the front housing as shown in the figure.
6.
To replace, align the front housing with the rear housing then firmly press
together until the catches engage and the housings are properly assembled.
7.
Replace the 6 screws and tighten firmly. Do not over tighten.
HOUSING SCREW,
October 23, 2001
6 PLACES
Disassembly
010702-A
20
Advertisement
Table of Contents
Troubleshooting
