Table of Contents
Advertisement
Troubleshooting
Symptom
Cannot fully deodorize
When seated,
deodorization function
does not operate
Water flows into the toilet
from under the body
when the seat is occupied
or unoccupied.
When the seat is
occupied, it feels shaky.
The removed body can't be
re-installed.
When the following situations are experienced, be sure to consult your dealer or one of Panasonic-operated service centers.
When the power plug is plugged back, the Power, Electrical Leakage, 8-hour Power Saving, Seat Temperature and
Water Temperature indicators still flash. (Unplug the power plug.)
When the power plug is plugged back, the Power indicator is still not on.
When smoke is seen or unexpected sound is heard. (Unplug the power plug.)
When there is no warm air from warm air outlet, or when the warm air suddenly turns cold during usage, try to unplug
and plug the bidet to restore normal functionality.
When the following situations are experienced, configured settings will be erased. A configuration of settings will be required.
Situation
When the power plug is plugged
When the Electrical Leakage Test button is
pressed
When power is down for 1 second or longer
26
Parts to be Checked, Cause & Solution
Is deodorization filter net blocked?
→ Use dry toothbrush to clean the deodorization filter net.
Does the seat indicator on control panel light up?
If user sits partially on the front of seat, seat occupancy sensor may fail
to detect.
→Even when user sits at the center of seat, and seat occupancy does
not detect, press occupancy button for 2 seconds to activate it. After
seat occupancy is detected, deodorization feature will operate.
At the start and end of each use, water for nozzle self-cleaning
will flow into the toilet. This is not a malfunction.
This can be resulted from a loosened mounting bolt. Tighten it.
As this product is designed with a detachable structure to enable
the body to be removed from the toilet, it may feel slightly
shaky after the product is tightened. This is not a malfunction.
The reason that the re-installation is not possible is because the body
mounting plate is bent due to an uneven toilet surface.
→If the body mounting plate is bent, loosen the top bolt slightly. Do not
loosen the top bolt excessively as it may cause shaking. After the body
mounting plate is straightened, install the body again.
Function to be Reconfigured
Warm air temperature
Volume Adjustment
8-hour Power Saving
Ref. Page
17
10
8
9
Installation
Instructions
7
—
Ref. Page
12
12
13
Advertisement
Table of Contents
