Table of Contents
Advertisement
3
<Left view>
Left hole
2
Right
axle
Remove the body for cleaning by following the steps below.
1
Unplug the power plug.
2
Close the water inlet valve completely to stop supplying water.
[Page 18]
3
Press and hold the body assembly /
disassembly button on the right side of
the body. Meanwhile, wiggle the body
gently, lift it up and pull it towards
yourself until the body slides out of the
body mounting plate.
As the water inlet hose is still attached at
this moment, do not pull with excessive
force.
4
Wipe off any dirt covered by the
toilet.
Use a piece of soft cloth soaked in water
and wrung out thoroughly.
5
Clean the body base.
2
Place the body on the toilet in the upright
position. With the body held in one hand,
wipe off the dirt on the body base by using
the other hand.
1
Do not rinse with water.
Please clean the dust when it is accumulated
at the air inlet for deodorization.
6
Re-install the body.
Align the protrusion on the back
side of the body with the one in the
center of the body mounting plate.
Lift up the rear part of the body slightly
and slide it towards the body mounting
plate until a "click" is heard.
Do not secure the power cord between
the body and toilet.
Lift up the body gently to check if it is
installed securely.
7
Open the water inlet valve to supply water. [Page 20]
1
8
Plug the power plug.
Note
When moving the body towards yourself (Step 3) placing it in the upright position
(Step 5), do not exert excessive force on the water inlet hose.
Do not place the body in the inverted position or it may be scratched.
Base (1 Time per Week)
towards self
Power
cord
Pull
Body assembly /
disassembly button
Body mounting plate
Air inlet for
deodorization
Protrusion
Protrusion
15
Advertisement
Table of Contents
