Panasonic DL-EH30SE-W Operation Instructions Manual page 21

Plastic film
6
Press and hold the rear left portion of the seat.
(The Occupancy indicator is on.) Meanwhile,
Press or
Deodorization starts. (with motor sound)
The nozzle starts self-cleaning. After approximately 5 - 8
seconds, cleaning water will be sprayed.
(If the Occupancy Switch isn't enabled, no water will be sprayed.)
Check if cleaning water is sprayed normally with the plastic film.
7
Press
Once the nozzle retracts, water for nozzle self-cleaning will
come out.
8
Remove the plastic film.
9
Press and hold the rear left portion of the seat.
(The Occupancy indicator is on.) Meanwhile,
Press , confirm warm air function , then press
10
Press and
After 5 - 12 minutes, sit at the seat to check the seat
and water temperature.
It takes approximately 5 - 12 minutes for the temperature of the
seat and warm water to stabilize. (Depending on ambient
temperature and the temperature of tap water.)
Power plug
Tips
After showering stops, droplets will fall from around the
nozzle. These are the water resulted from thermal expansion
of the warm water tank or water remaining in the nozzle. This
is not a malfunction.
(Approximately 7 - 8 minutes after showering)
to set the temperature. [Page 12]
.
21