Table of Contents
Advertisement
Tips of rear and front showering
Both functions are intended for cleaning of the dirt on certain body parts.
Do not use these functions for an extended period of time or excessively. (Risk of body's bacterial imbalance from
loss of normal flora)
When the product is to be used by patients receiving any local treatment, consult the doctor first.
2
3
Stop
Showering
Press
to stop
showering.
At this time, the
nozzle retracts
and cleans itself
again.
Tips
Operating sound will be heard when the nozzle extends and retracts. This is not a malfunction.
It takes some time to switch between front and rear showering.
Even if it feels comfortable in the beginning, low temperature burn may result from sitting on the seat for a long time.
Set the seat temperature to the low or off position. [Page 12]
The warm water tank of the body has a capacity of approximately 0.6 L. The water temperature will decrease during
continuous showering. Stop showering and wait 5 - 7 minutes until the temperature increases.
(The duration for the temperature to increase depends on the temperature of the supplied water.)
Once showering stops, droplets can be found near the nozzle. These are water from thermal expansion of the water tank
or the water remaining in the nozzle. This is not a malfunction. (This occurs approximately 7 - 8 minutes after showering.)
For safety and power saving, the showering and warm air functions will stop automatically once being used continuously
for 5 minutes.
After pressing Occupancy button, the stop time of Shower, Auto Deodorization or Warm Air:
Automatically stop after the Rear Showering or Front Showering button is pressed and 1 minute of continuous showering.
Auto deodorization starts. Deodorization stops after shower wash stops around 1 minute 30 seconds.
After pressing "Warm Air" button and continuously operate for 5 minutes, it automatically stops.
Occupancy button / indicator
4
Warm air
function
Press
then warm air blows out
(drying becomes faster
after the water drops are
wiped away with a piece
of toilet paper).
After pressing the button,
the shower pressure/warm
air temperature indicator turns
on. Adjust the temperature
of the warm air according
to own situation.
[Page 12]
The indicator turns on.
5
Stop
When the seat is unoccupied, the
Occupancy indicator will be off.
Warm
air
function
Press
After leaving from seat, deodorization
function will continue to operate for
1 minute, then automatically stops.
When the seat occupancy is activated,
※
if shower or warm air functions do not
operate for 30 seconds continuously,
system will assume the status as "not
seated".
Close the lid after each use.
Exit
Off
11
Advertisement
Table of Contents
