Control Panel - Silhouette DIM32D2BSSPR Owner's Manual

OPERATING INSTRUCTIONS
FEATURES - FRONT
1. Ice bucket
2. Bottom board of ice bucket
3. Front drain cap
4. Front drain seal
5. Water level indicator
6. Rear drain seal
7. Rear drain cap
1
4
3
FEATURES - REAR
1. Water inlet
2. Drain pump outlet
3. Drain pump cap
4. Direct drain outlet
5. Direct drain cap
6. Braided drain hose (not pictured)
FEATURES - INTERNAL
1. Continuous drain water tank
2. Internal water tank
1
2
7
6
5
2

CONTROL PANEL

Ice cube sizes differ by density and not volume. A
large ice cube is the same size as a small ice cube
but contains more frozen water.
1. Small ice cube button
2. Medium ice cube button
3. Large ice cube button
4. Power button
The ice maker is automatically set to make medium
ice. To change the size of the created ice, press the
desired ice size button.
To stop making ice but to keep the appliance on
standby, press and hold the power button for 3
seconds. The power indicator light will flash to
indicate standby mode. Do not leave the appliance
in standby mode for more than 6 hours. To resume
making ice, press the power button again.
This appliance can produce up to 32 lbs. of ice
daily. The ice bucket capacity is 25 lbs.
When new ice is created, remove it from the
appliance and place it in a freezer for long term
storage.
WATER FILTER
It is highly recommended to use a water filter on
the water source connected to this appliance and
replace the filter regularly. A water filter works to
remove sediments such as dirt, rust and other debris
that are not visible to the naked eye, but which exist
in all water sources and can appear as scale on the
surfaces of the machine. These contaminants can
negatively affect the quality of the ice produced,
a failure to product ice, restrict water flow to the
appliance and can increase wear and tear on the
appliance.
8