Troubleshooting - Silhouette DIM32D2BSSPR Owner's Manual

TROUBLESHOOTING

Hours of operation:
Monday to Thursday 8:30 am - 6:00 pm Eastern Standard Time
Friday 8:30 am - 4:00 pm Eastern Standard Time
Information in this manual is subject to change without notice.
No power
The ice is not big enough or melts too quickly
Water leakage
Excessive noise or vibrations
Ice maker alarm is sounding
INDICATOR LIGHT
Silhouette Consumer Care: 1-844-455-6097
PROBLEM
DESCRIPTION
1. Flashing
2. On
3. Off
Flashing and
beeping
Flashing
Flashing
Flashing
Flashing
• A fuse may be blown or the circuit breaker
tripped
• Plug not fully inserted into the wall outlet
• Door is not shut properly or opened excessively
• Close proximity to heat source or direct sunlight
• Ambient temperature or humidity is very high
• Chosen ice size setting is too small
• The water inlet connection is leaking
• The drain hose connection is leaking
• The drain caps on the ice bucket are not
completely closed
• Deflector plate not hanging in the right place
• Ice bucket backward installation
• Out of level
• The appliance is not level
• Internal water tank is full
• Not enough water entering the appliance from
the water inlet
1. Stand by mode
2. Appliance is on
3. Appliance is off
Water tank is full; drain appliance of excess water or ensure
that the drain pump is turned on to resume normal functioning
Ice bucket is full of ice; remove excess ice to resume normal
functioning
Sensor failure; contact an authorized service technician
Appliance is low on water; check that the water supply is
functioning normally
Sensor failure; contact an authorized service technician
14
POSSIBLE CAUSE
POSSIBLE CAUSE