Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION INSTRUCTIONS
LOCATION
•
Two people should be used when moving the
appliance.
•
Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
•
Place the appliance on a floor that is strong
enough to support it when it is fully loaded.
•
Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
•
This appliance is intended for household use
only. It is not designed for outside installation,
including anywhere that is not temperature
controlled (garages, porches, vehicles, etc.).
•
Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
•
This appliance is 15 inches (38 cm) wide by
34.3 inches (87 cm) high by 24.2 inches (61.4
cm) deep.
•
The ice maker should be placed in an area
where the ambient temperature is between 54°F
- 95°F (12°C - 35°C). If the ambient temperature
is above or below this range the performance of
the appliance may be affected.
FRONT VENT
This appliance is front breathing. Do not block the
front air vent as this will result in high operating
temperatures, higher energy usage and possible
system overheating and failure.
LEVELING INSTRUCTIONS
It is important for the ice maker to be leveled in
order to work properly; Otherwise water will
not flow as it should through the evaporator. Ice
production will be less than normal, and operation
will be noisy. Water will leak from front or back
from ice maker to the floor.
The ice maker can be raised or lowered by four
leveling legs on the bottom of the machine. If you
find that the surface is not level. You may need to
make several adjustments to level the machine.
We recommend using a carpenter's level or round
bubble levels to check it.
1. Move the ice maker to its final location;
2. Place a carpenter's level or round bubble levels
on top of the product to see if the ice maker is
level from front to back and side to side;
3. Adjust the height of the legs as follows:
Turn the leveling leg counter-clockwise as far as
it will go, until the top of the foot is touching the
bottom of the chassis. Slowly turn the leveling leg
clockwise until the appliance is level
IMPORTANT: Once you are ready to install it in a
cabinet or directly on the floor, you must adjust the
legs to level the ice maker
3
Advertisement
Table of Contents
