Subnet-Based Vlan Commands - ZyXEL Communications Dimension GS-3012 Cli Reference Manual

C
H A P T E R

Subnet-based VLAN Commands

Use these commands to configure subnet-based VLANs on the Switch.
56.1 Subnet-based VLAN Overview
Subnet-based VLANs allow you to group traffic based on the source IP subnet you specify.
This allows you to assign priority to traffic from the same IP subnet.
See also Chapter 46 on page 155
page 199 for VLAN commands.
56.2 Command Summary
The following section lists the commands for this feature.
Table 119 subnet-based-vlan Command Summary
COMMAND
show subnet-vlan
subnet-based-vlan
subnet-based-vlan dhcp-vlan-
override
subnet-based-vlan name <name>
source-ip <ip> mask-bits <mask-
bits> vlan <vlan-id> priority
<0-7>
subnet-based-vlan name <name>
source-ip <ip> mask-bits <mask-
bits> source-port <port> vlan
<vlan-id> priority <0-7>
subnet-based-vlan name <name>
source-ip <ip> mask-bits <mask-
bits> vlan <vlan-id> priority
<0-7> inactive
no subnet-based-vlan
Ethernet Switch CLI Reference Guide
for protocol-based VLAN commands and
DESCRIPTION
Displays subnet based VLAN settings on the Switch.
Enables subnet based VLAN on the Switch.
Sets the Switch to force the DHCP clients to obtain their IP
addresses through the DHCP VLAN.
Specifies the name, IP address, subnet mask, VLAN ID of the
subnet based VLAN you want to configure along with the
priority you want to assign to the outgoing frames for this
VLAN.
Specifies the name, IP address, subnet mask, source-port
and VLAN ID of the subnet based VLAN you want to
configure along with the priority you want to assign to the
outgoing frames for this VLAN.
Note: Implementation on a per port basis is not
available on all models.
Disables the specified subnet-based VLAN.
Disables subnet-based VLAN on the Switch.
56
Chapter 62 on
M P
E 3
C 13
C 13
C 13
C 13
C 13
C 13
183