Mac Filter Commands - ZyXEL Communications Dimension GS-3012 Cli Reference Manual

C
H A P T E R
Use these commands to filter traffic going through the Switch based on the MAC addresses
and VLAN group (ID).
Use the running configuration commands to look at the current MAC filter
settings. See
MAC filtering implementation differs across Switch models.
• Some models allow you to specify a filter rule and discard all packets with the specified
MAC address (source or destination) and VID.
• Other models allow you to choose whether you want to discard traffic originating from the
specified MAC address and VID (src), sent to the specified MAC address (dst) or both.
See Section 33.2 on page 120
33.1 Command Summary
The following section lists the commands for this feature.
Table 79 mac-filter Command Summary
COMMAND
mac-filter name <name> mac <mac-
addr> vlan <vlan-id>
no mac-filter mac <mac-addr>
vlan <vlan-id>
mac-filter name <name> mac <mac-
addr> vlan <vlan-id> inactive
no mac-filter mac <mac-addr>
vlan <vlan-id> inactive
mac-filter name sourcefilter mac
<mac-addr> vlan <vlan-id> drop
<src|dst|both>
Ethernet Switch CLI Reference Guide

MAC Filter Commands

Chapter 51 on page 167.
and Section 33.3 on page 120
DESCRIPTION
Configures a static MAC address port filtering rule.
name: 1-32 alphanumeric characters
Deletes the specified MAC filter rule.
Disables a static MAC address port filtering rule.
name: 1-32 alphanumeric characters
Enables the specified MAC-filter rule.
Specifies the source and or destination filter parameters.
33
for examples.
M P
C 13
C 13
C 13
C 13
C 13
119