Rear Panel; Power Connector; Leds; Figure 13 Rear Panel - ZyXEL Communications Dimension ES-1552 User Manual

Chapter 3 Hardware Overview
When you use the RESET button all of your configuration settings will be lost.
Use the default IP address (192.168.1.1) and user name (admin) and
password (1234) to log back into the switch. It may take up to 2 minutes for the
switch to restart when you reload the default configuration file.

3.3 Rear Panel

The following figures show the rear panels of the AC power input model switch. The rear
panel contains a connector for the power receptacle.

Figure 13 Rear Panel

3.3.1 Power Connector

Make sure you are using the correct power source as shown on the panel.
To connect the power to the switch, insert the female end of power cord to the power
receptacle on the rear panel. Connect the other end of the supplied power cord to a 100~240V
AC, 0.8A power outlet.

3.4 LEDs

The following table describes the LEDs.

Table 2 LEDs

LED
PWR
10/100 Mbps Ethernet Ports
LNK/ACT
Gigabit Ethernet Ports
38
COLOR STATUS DESCRIPTION
Green On The system is turned on.
Off The system is off.
Amber Blinking The system is transmitting/receiving data to/from a 10/100 Mbps
Ethernet network.
On The link to a 10/100 Mbps Ethernet network is up.
Off The link to an Ethernet network is down.
ES-1552 User's Guide