Table of Contents
Advertisement
Issue 1.2 18/07/03
3
ASSEMBLY INSTRUCTIONS
General Assembly : SRP12 Pump Unit
The pump unit is provided as a complete assembly and is not recommended for piece part
replacement.
General Assembly : SLF12 Linear Feedback Unit
The linear feedback unit is provided as a complete assembly and is not recommended for piece
part replacement.
General Assembly : SCP12 Course Programmer
Refer to Drawing No.
foam strip and secure with a single screw (200130) through the centre hole. Fit the PCB into the
bottom case over the remaining 2 posts and locate Kool Pads (200189) between each drive FET
and the heat sink. Secure each FET to the heat sink using 4 screws (200130) each fitted with an
insulating washer (200081), Fit the rear section of the top case (E02898:BK) and secure with 4
screws (200235) through the case bottom. Fit the front section of the top case (E03679) and
secure with the 3 screws (200002).
General Assembly : SFC12 Control Unit
Refer to Drawing No.
E02904:BK, gasket E03099, case bottom (E02902:BK) and grommet (E03701) and terminate it on
the PCB. Fit the PCB into the bottom case. Fit Gasket (E03702) into the recess in the bottom
case and fit the top case (E03676) onto the bottom case ensuring that the case seal remains
correctly located. Fit the 4 off Pan Poz Drive Screws into the 4 recessed holes in the case bottom
and screw up firmly to retain the case top.
General Assembly : SJB12 Junction Box
Refer to Drawing No. SJB12. The drawing is self explanatory and needs no further explanation.
General Assembly : SHS12 Heading Sender
Refer to Drawing No.
(E02781:BK) and grommet (E03701) and terminate it on the PCB. Fit the PCB complete with
compass into the bottom case. Fit gasket E02783 in the recess in the top case and fit the top case
onto the bottom case using 2 off 200235 screw No. 4 x 1" and 1 off 200137 screw No.4 x 3/4" each
fitted with a washer 200184. NB. The short screw is used in the front of the case with the longer
screws to the flat edge at the rear.
General Assembly : SHC14 Remote Control
Refer to Drawing No.
(E02737:BK) and grommet (E03701) and terminate it on the PCB. Locate the 5 screw boss seals
(E02555) and fit the PCB into the case rear carefully locating it onto the screw boss seals and
secure with the 2 screws (200139) complete with washers (200081). Locate the case seal
(E02541) into the groove in the case rear and fit the case top assembly to the case rear and
secure using the 5 screws (200139).
SCP12
and locate the heat sink (E02900) over the 2 posts and the rear case
SFC12
and fit the screened cable (E02922) through the retaining nut
SHS12
and fit the screened cable (E02922) through the case bottom
E03709
and fit the cable assembly (E03281) through the case rear
SIMRAD
8
Advertisement
Table of Contents
