E43 DRIVE Assy R6
Ei main Assy
@ Remove the four screws.
@ Disconnect the flexible cable from DVJB Assy.
@) Stand the MAIN Assy.
@ Remove the two screws.
© Remove the two screws.
@ Remove the three screws.
@® Disconnect the connector.
@ Remove the DRIVE Assy Ré.
DVJB Assy
MAIN Assy
DRIVE Assy R6
6 | Diagnosis
@ insert the insulation sheet between the MAIN Assy and chassis.
@® Arrange the unit as shown in the photo below.
Caution:
MAIN IC (IC1001) on the MAIN Assy generate heat to around 80 degrees.
Be careful when works.
SCRB Assy
(1) Insulation sheet
1C1001
MAIN Assy fp)
Flexible cable (40P)
ATA Assy
EJ TUJB Assy
[e] power suppLy unit
FRJB Assy
DRIVE Assy R6
99