Table of Contents
Advertisement
i How to Input the ID Number and ID Data
Note:
Be sure to enter the ID number in Stop mode.
Use the service remote control (GGF1381) for operations. Only opening/closing of the tray are performed from the player.
The ID data disc is swept out automatically after the recorder has read the data from it.
(@ To enter the input mode, press|[ESC]+[STEREO} sequentially in
a status with no ID number set, such as after FLASH-ROM
downloading.
4
@) As number input is enabled when the unit enters the input
mode,
input the 9-digit ID number.
(The entered number is also displayed on the FL display.)
[Recorder's ID Number Setting]
ID Number ?
<CLEAR>
Exit
Input ID Number !
4
@) After inputting the number, press[SEARCHto register the ID
number.
[Recorder's ID Number Setting]
ID Number ?
>000000001
OK?
<PLAY>
Compare Mode
@—* <SEARCH>
Enter
Input ID Number !
4
@) When the ID number has been registered, the unit enters the ID
data input mode.
(The FL display indicates "INSERT ID.")
In this condition, place the ID data disc on the tray and close the
tray using the CLOSE key "mgi/" on the player.
[Recorder's ID Data Setting]
<CLEAR>
Exit
@—— Insert The ID Data Disc !
76
® While the data are being read, the message shown in the figure
at left is displayed on the screen.
(The FL display indicates "LOAD ID.")
[Recorder's ID Data Setting]
()— Loading The ID Data Disc !
4
© When the ID data have been read, the data are written to the
FLASH-ROM.
(The FL display indicates "WRITE ID.")
[Recorder's ID Data Setting]
©—
Wait Rom Writing !
4
@ When the ID data have been written to the FLASH-ROM, the
message "Rom Write Ok" is displayed on the screen.
(The FL display indicates "ID DATA OK.")
@® Atter confirming this message, press (CLEAR}to exit the input
mode.
[Recorder's ID Data Setting]
@—> Rom Write OK !
<CLEAR>
Exit
Advertisement
Table of Contents
