Installation And Configuration; Installation Preparation - Pytes Pi LV1 User Manual

5. Installation and configuration

5.1 Installation preparation

5.1.1 Safety Requirements
Only those who have been trained in the power system and have a good knowledge of the
power system are allowed to install the Product. Always observe local safety regulations and
the safety requirements listed below during the installation process.
Before installing or removing the battery, make sure that the system is disconnected from any
power source and that the battery is off state. Distribution cabling needs to be handled carefully
with protective measures.
5.1.2 Checking the operating environment
The operating environment should meet the requirements described in Chapter 4, "Operating
Environment".
5.1.3 Tools and Safety Gears
The tools that may be used are shown in Table 5-1.
Table 5-1 Tools
Screwdriver
Cable Clamp
Use properly insulated tools to prevent accidental electric shock or short circuits. If insulated
tools are not available, cover the entire exposed metal surfaces of the available tools, except
their tips, with electrical tape.
Insulated Gloves
It is recommended to wear safety gears when dealing with the Product.
5.1.4 Technical preparation
Electrical interface settings:
If the battery is connected to the user device directly, please check:
Whether the DC charging interface of the energy storage inverter meets charging voltage
and current requirements in Table 1-1 Specifications.
Whether the power of the electrical equipment matches the parameters listed in "Table 1-1
Specifications".
Security check:
Fire-fighting equipment such as portable fire extinguishers should be available near the Product.
Follow the instructions in Chapter 4 for environment requirements.
Tools
Electric Drill
Wire Cutter
Safety Gear
Safety Goggles
15
Pencil
Ruler
Safety shoes