Table of Contents
Advertisement
To delete administrator access from a specific IP address:
1. Select the IP Address you want to delete from the IP Address table.
2. Click Delete.
Important Notes:
•
Configuring different access permissions for LAN and Internet is not supported when your
Internet Connection is configured in bridge mode (the option Allow administration access
from does not show Internet or LAN).
•
An automatic implied rule is defined to allow the access specified here. There is no need to add
an explicit rule in the Access Policy page to allow this access.
•
When you block the IP address or the interface group through which you are currently
connected, you are not disconnected immediately. The access policy is applied immediately,
but your current session remains active until you log out.
Managing Device Details
In the Device > Device Details page, you can:
•
Enter an Appliance Name for the appliance to identify the Check Point Appliance.
Note - The appliance name can only contain alphanumeric characters and the hyphen
character. Do not use the hyphen character as the first or last character.
Important - If the gateway's Internet connection is assigned an IP address dynamically
and the identifier option in SmartDashboard is set to Gateway name, the Appliance
Name must be identical to the Check Point Appliance name defined for the Check Point
Appliance object in SmartDashboard.
•
For wireless devices only - Configure the Country. The allowed wireless radio settings vary
based on the standard of each country.
•
Assign a Web portal certificate.
To assign a Web portal certificate:
1. Click the downward arrow next to the Web portal certificate field.
The list of uploaded certificates shows.
2. Select the desired certificate.
3. Click Apply.
4. Reload the page.
Managing Date and Time
The Device > Date and Time page shows the current system time and lets you define the Check
Point Appliance date and time, optionally using NTP.
To manually configure date and time:
1. Select the Set Date and Time Manually option.
2. Enter the current Date and Time. Click the calendar icon to enter the date. Specify whether the
time is AM or PM.
3. Click Apply.
Check Point 1100/1200R/1400 Appliances Centrally Managed Administration Guide R77.20.75
Appliance Configuration
|
88
Advertisement
Table of Contents
