Restoring Factory Defaults - Infinity Check Point L-71WD Administration Manual

Restoring Factory Defaults

The Check Point Appliance contains a default factory image.
When the appliance is turned on for the first time, it loads with the default image.
As part of a troubleshooting process, you can restore the Check Point Appliance to its factory
default settings if necessary.
You can restore a Check Point Appliance to the factory default image with the WebUI, Boot Loader,
or a button on the back panel.
Important - When you restore factory defaults, you delete all information on the
appliance and it is necessary to run the First Time Configuration Wizard.
To restore factory defaults with the WebUI:
1. In the Check Point Appliance WebUI, click Device > System Operations. The System
Operations pane opens.
2. In the Appliance section, click Factory Defaults.
3. In the pop-up window that opens, click OK.
4. While factory defaults are restored, all LAN Link and Activity LEDs blink orange and green
alternately to show progress.
This takes some minutes. When this completes, the appliance reboots automatically.
To restore factory defaults with the button on the back panel:
1. Press the Factory Default button with a pin. Hold for at least
1400 appliances - 12 seconds.
Other appliances - 3 seconds.
2. When the Power and Notice LEDs are lit red, release the button. The appliance reboots itself
and starts to restore factory defaults immediately.
3. While factory defaults are restored, all LAN Link and Activity LEDs blink orange and green
alternately to show progress.
This takes some few minutes. When this completes, the appliance reboots automatically.
1100 and 1200R appliances:
To restore the Check Point Appliance to its default factory configuration using U-boot
(boot loader):
1. Connect to the appliance with a console connection (use the serial console connection on the
back panel of the appliance).
2. Boot the appliance and press Ctrl-C.
The Gaia Embedded Boot Menu is shown.
Welcome to Gaia Embedded Boot Menu:
1. Start in normal Mode
2. Start in debug Mode
3. Start in maintenance Mode
4. Restore to Factory Defaults (local)
5. Install/Update Image/Boot-Loader from Network
Check Point 1100/1200R/1400 Appliances Centrally Managed Administration Guide R77.20.75
Advanced Configuration
| 119