50-60Hz Chuck Type Keyless Chuck Size 6.5mm No-load Speed 0-4300 RPM Weight 1.5kg Supplied in Ronix color box includes Chuck key PART LIST Drill chuck Direction switch Operating switch Locking button GENERAL POWER TOOLS WARNING WARNING! - Read all safety warnings and all instructions, Failure to follow the warnings and instructions may result in electric shock, fire and or serious injury.
WORK AREA SAFETY - Keep work area clean and well lit. cluttered or dark areas invite accidents. - Don’t operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes.
Page 4
operating power tools may result in serious personal injury. - Use personal protective equipment. Always wear eye protection. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. - Prevent unintentional starting.
Page 5
- Store idle power tools out of the reach of children and don’t allow persons unfamiliar with power tool or these instruction to operate the power tool. Power tools are dangerous in the hands of untrained users. - Maintain power tools. Check for misalignment or binding of moving parts, breakage o parts and any other condition that may affect the power tool’s operation.
Always be sure that the tool is switched off and unplugged before installing or removing the bit. FOR MODEL 2107A WITH KEYLESS CHUCK To install the bit, loose chuck by hand and place bit in the chuck as far as it will go, and then tighten the chuck by hand. For fixing the bit well, keep the chuck and switch on machine for some seconds.
SWITCH ACTION CAUTION Before plugging in the tool, always check to see the switch trigger actuates properly and returns to the OFF position when released. To start the tool, simply pull the switch trigger. Release the switch trigger to stop. For continuous operation, pull the switch trigger and then push in the lock button.
- Because the carbon brush is internal, so please change the brushes by RONIX SERVICE maintenance service center. - After placing the new carbon brushes, Let the tool run for some minutes so that the brushes fit better.
Page 9
REPAIRS Please only use accessories and spare parts recommended by RONIX. If the tool get malfunction, please hand over the tool to RONIX dealer or appointed RONIX SERVICE maintenance station. Don’t disassemble the tool by yourself or replace the parts supplied by others.
Need help?
Do you have a question about the 2107A and is the answer not in the manual?
Questions and answers