Ronix 2210C Manual

Ronix 2210C Manual

Impact drill 13 mm


Quick Links



Table of Contents

Summary of Contents for Ronix 2210C

  • Page 1 IMPACT DRILL 13 mm 2210C...
  • Page 2: Specification

    SPECIFICATION Voltage 220V/ 50Hz Input power 810W No load speed 0-3000RPM Chuck size 13mm Steel 13mm Concrete 13mm Wood 25mm Net Weight 2.4Kg NOTE: Please keep this instruction manual for future reference. PARTS LIST Hammer/Rotary Selector Depth Lock Stop Guide Button Direction Speed...
  • Page 3: Work Area

    1) Speed selection: With the speed selection via the regulator wheel you have optimum control of the machine. 2) Lock button: The machine can be set to continuous operation with locking button. 3) Adjustable Hand grip: The second handle gives you an additional way the holding the machine firmly.
  • Page 4: Electrical Safety

    may ignite the dust or fumes. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. - Keep bystanders, children, and visitors away while operating a power tool. Distractions can cause you to lose control. ELECTRICAL SAFETY - Power tool plugs must match the outlet.
  • Page 5 on. A wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. - Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations.
  • Page 6: Operation And Use

    SPRCIAL SAFETY INFORMATION FOR DRILL - When drilling screwing into walls, ceiling etc. make sure beforehand that you will not damage any hidden electric cables, during this work you should not touch metal parts of the machine. Only touch the machine by the plastic housing.
  • Page 7 ADJUSTING THE DEPTH STOP GUIDE - The second handle has a retainer for the depth Stop Guide. - Insert a drill. - Now release the handle. - Push the bit stop forwards until its end is in line with the end of the drill. Now push the depth Stop Guide back until the distance between the end of the bit and the end of the drill corresponds to the depth to which you would like to drill.
  • Page 8: Drilling Tips

    WORKING WITH THE DRILLING MACHINE Ensure that the mains power supply voltage is the same as the operating voltage of your machine. For details, please see the type plate. Insert the correct drill for the type of job to be performed. If necessary, adjust the bit stop.
  • Page 9 - Set the direction switch to the correct direction. - Never change the direction of motion when the machine is switched on. CARE OF THE TOOLS OVERLOAD Never use excessive force when drilling. Too much pressure reduces the speed of the machine, and the required power is greatly reduced. This may result in overload, which can damage the motor of the drilling machine.

Table of Contents