Kenwood KR-V6020 Instruction Manual page 12

Operating instructions
REMOTE SENSOR
INPUT SELECTOR keys
1 Aas. 100FM-20 PRESETS
WEVARIABLE LOUDNESS
CONTROL
DISCRETE POWER
AMPLIFIER CIRCUITRY
CO DIRECT
INPUT. SELECTOR 'ON STAND BY
Ph
Ones A SPEAKERS 8 4
2 ON DOFF
TREBLE control key
POWER key
POWER STAND BY indicator BASS control key
M@ Basic operation
1. Press the POWER key to ON.
@ The display lights and the unit becomes operative.
@ Pressing the key again switches the power OFF.
2. Press one of the INPUT SELECTOR keys to select the in-
put source to be played.
®@ |f a System Control cord has been connected to the
selected source component, it starts play automatically
due the Automatic Play operation feature.
@ With the Automatic Play operation feature, when one
of the source components is started to be played, the
corresponding input selector is automatically switched
for the source.
@ The selected input source is shown on the display.
3. If automatic play operation using the System Control
cords has not been set, start playing the source compo-
nent selected.
4. Adjust the output level with the VOLUME CONTROL
knob.
5. Adjust the balance of the left and right output levels with
the BALANCE control knob.
6. Adjust the tone (BASS, TREBLE) for your preference.
Note:
When the TAPE-2 selector switch is set to ON, the input source
selected with the input selector keys cannot be heard from the
speakers. To listen to a source other than tape deck 2, be sure to
set the TAPE-2 selector key to OFF.
12 KR-v6020 (En)
MEMORY key
AUTO key
Proven | [wosst woot rapa [roe [ae peste] Fey Breer
|
=10 30+ oO x
ES EC
LOUDNESS
control
VOLUME CONTROL knob
Numeric keys
VOLUME CONTROL
14:18 46
2i3 Lary
C= surround
BALANCE | 2 4 REAR LEVEL INPUT BALANCE
BALANCE
P.SCAN key
control knob
TUNING key
@ Principal key function
TUNING key
Used to change the frequency.
AUTO key
Press this key to select the tuning mode between AUTO or
MANUAL. In MANUAL mode, FM stereo broadcasts are
received in monaural.
indicator ON + — AUTO mode
AUTO indicator OFF -— Manual mode
MEMORY key
This key is used to store the station frequency in memory.
Numeric {1 ~ 10/0) keys
Use these keys to:
1) input directly the digits of frequencies, or
2) store and recall frequencies in the preset channels.
Tone control knobs (BASS) (TREBLE)
Adjust tone controls to suit your taste.
BALANCE control knob
If an imbalance occurs (the left or right channel appears loud-
er than the other) due to source imbalance or room acoustics,
adjust BALANCE control to equalize the sound from both
speakers.
LOUDNESS control knob
When listening to the music at low volume level, the low fre-
quency sound may seem unsatisfactory. In this case, the lack
of the low frequency sound can be compensated with this con-
trol to make the sound richer (as desired).
POWER STAND-BY indicator
This indicator lights if the power cord is plugged into the AC
outlet. It is lit to show that the POWER switch on the front panel
or the POWER key on the remote control unit can be activated.
REMOTE SENSOR
Point the supplied remote control unit towards this sensor and
operate.