Front Panel Facilities - Pioneer CT-W630R Operating Instructions Manual

Stereo double cassette deck
Hide thumbs Also See for CT-W630R:
Table of Contents

Advertisement

FRONT PANEL FACILITIES
®
©
©)
Ss
D
@
®
POWER (STANDBY/ON)
switch
The unit POWER switch is geared to selecting the transform-
er secondary and so even at the STANDBY
position, the unit
circuitry will work as long as the power cord is connected to
a power outlet.
PHONES jack
To insert headphones jack.
REC LEVEL control
REC BALANCE control
Balances the recording level between left (L} and right (R) chan-
nels. (See page
11)
DECK i! tape COUNTER
and RESET button
Resets the tape counter reading to ''000"'.
{The tape COUNTER
works for deck Ii only.}
Recording mute button ( © }
Pressing this button during recording, creates a blank portion
of approximately 4 seconds on the tape. The unit then enters
the recording pause mode. (See page 11)
Pause button (88)
Stops tape transport temporarily during recording or playback.
Press the button again to resume operation. {This can also be
done by pressing the Play {® or 4) button.) This button does.
not work during fast-forward and rewind.
Recording button ( @)
When the recording { @ } button is pressed, the unit is set to
recording standby mode. Press the pause (88) button or play-
back {® or ) button when ready to record.
The unit will not enter the recording standby if a cassette with
broken erasure prevention tabs is loaded.
Only deck tis equipped
with a recording function.
<RRBI058>
®
©
®
®
@® ({CT-W630R only)
(@) EJECT button ( # )
Press to open the cassette door after you have pressed the
stop (M) button and the tape has stopped.
NOTE:
if the power is turned off while the tape is moving,
the cas-
sette door may remain locked, In this case, turn the power on
before pressing the EJECT button ( &).
0) DOLBY* NR switch
Set this switch to B or C for recording with the built-in Dolby
Noise Reduction Systems and for playback of tapes which have
been recorded using the Dolby Noise Reduction Systems. To
play other tapes, set the DOLBY
NR switch to OFF.
When the DOLBY NR switch is set to ON, the MPX filter func-
tion operates in synchronization with the Dolby noise reduc-
tion system. The operation of this filter may causes some high
frequencies to be muted when the Dolby NR system is used
for recording of FM broadcasts from some tuners.
°
Dalby noise reduction manufactured under license trom Dol-
by Laboratories Licensing Corporation.
*
"DOLBY" and the double-D symbol QQ are trademarks of
Dolby Laboratories Licensing Corporation.
{CT-W630R only)
*
Dolby noise reduction and HX Pro headroom
extension
manufactured under license from Dolby Laboratories Licens-
ing Corporation. HX Pro originated by Bang & Olufsen.
°
"DOLBY", the double-D symbol BQ and "HX PRO" are
trademarks of Doiby Laboratories Licensing Corporation.
NOTE:
When playing back Dolby NR-encoded tapes, always set this
Switch to the same position (B or C) used for recording.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ct-w530r

Table of Contents