Front Panel Facilities - Pioneer CT-W503R Operating Instructions Manual

| FRONT PANEL FACILITIES
| REVERSE MODE SWITCH (REV MODE)
| (CT-W503R/CT-W403R)
There are three settings:
One way mode = position
When the switch is set to this position, playback or recording is
performed on one side of the tape only. When the tape reaches
the end of the side, it stops automatically (auto stop function}.
Two way mode = position (CT-W503R/DECK H of
CT-W403R only)
When the switch is set to this position, playback or recording can
be performed on both sides of the tape. When the tape reaches
the end of the first (lorward) side, its direction is automatically
reversed, and playback or recording continues on the other
(reverse) side. When it reaches the end of the reverse side, the
tape stops automatically (auto stop function). ff playback or re-
carding is started from the reverse side, the tape will stop when it
reaches the end of that side.
Repeat mode = position (RELAY/SKIP) (CT-
W503R/DECK II of CT-W403R only)
When the switch is set to this position for playback, both sides of
the tape are played back repeatedly until the stop (il) button is
pressed, or until the tape has been played completely 15 times (16
sides). If the pause button is pressed to pause the tape, and then
playback is restarted, the repeat mode starts over from the begin-
ning, and will play the tape 15 times (sixteen sides).
When the switch is set to this position for recording, both sides
are recorded and then the tape stops, as described above for the
two way mode.
[DECK | of CT-W403R]
When playback continued until the end of the tape, the rewind
auto play mode is engaged. The tape will then be automatically re-
wound and played back again until the end of the tape. The rewind
auto play mode will continue to repeat this function 16 times until
the stop {ill) button is pressed.
Note for CT-W5G3R/CT-W403R
lf Deck | and lI are loaded with tapes, each tape will be played
using relay playback.
REPEAT PLAYBACK (RELAY/SKIP) (CT-W203)
'f Deck | and lf are loaded with tapes, each tape will be played
using relay palyback.
OPERATION OF DECK I WITH A REMOTE
| CONTROL UNIT NOT DESIGNED FOR :
, DOUBLE DECKS (System remote control)
Selecting DECK I
In order to operate DECK | with the remote control unit, adjust the
unit as follows: With the power off, press and hoid the stop (lM)
button of DECK |, and turn the power on. Continue to hold the stop
(Ml) button for approximately five seconds. DECK | can now be
operated using the remote control unit, but DECK #! cannot.
Switching to DECK tt
To restore remote contro! operation to DECK il, press the stop (i)
button of DECK Il while DECK I! is in stop mode. DECK I! can now
be operated using the remote control unit. Remote contro! oper-
ation can be switched back and forth between decks by pressing
the stop button of the desired DECK while it is in stop mode.
8
<RRBI142>
En
NOTE: a Rican!
ao nny
|
| only)
| AUTO-NR (CT-W503R only)
NOTE: