Front Panel Facilities - Pioneer CT-S800 Operating Instructions Manual

FRONT PANEL FACILITIES
QYFUD ABER crenco cassette neck (T-S800
Powr/,.
@ POWER switch
Turn the power on.
After the power is turned on, the dotted lines in the level
meter flash for approximately 4 seconds until the circuits
of the unit have stabilized. The unit will not operate during
this time even if one of the operation buttons is pressed.
@ Cassette door OPEN/CLOSE button
NOTE:
If the cassette door is closed while the unit is turned OFF, and the
power is then turned ON, the cassette door may open and close
after pressing one of the operation buttons. This occurs when the
microprocessor resets the door mechanism to its initial state and
does not indicate any malfunctioning of the unit.
3] COUNTER selectors
RESET:
Resets the counter indication to '"O000."'
MODE:
Each time this button is pressed, one of the following three
modes is set in sequence.
® Normal tape counter
© Time counter (displays the elapsed playback or recording
time)
¢ Remaining time counter (displays the remaining time of
the tape)
6
<RRB1026>
@ TAPE CAPACITY selector
To indicate the correct time value in the remaining time
counter mode, this selector must be set in accordance with
the tape used.
_——= C90 > C80L ~ C60 > C46L a
@ TAPE RETURN button
This button is used in the tape counter mode to fast forward
or rewind the tape to a point near the counter reading
"*0000"'.
(6) DOLBY NR selectors
ON/OFF:
Used to turn the Dolby NR system circuits ON or OFF.
B/C:
With the ON/OFF switch in the ON position, Dolby B or C
can be selected with this switch.
@ MPxX FILTER switch
This switch is effective only during recording with Dolby NR.
© REC LEVEL control
© REC BALANCE control