Installation And Removal; Din-35 Rail - WAGO 787-3861/108-020 Manual

Installation and Removal

7 Installation and Removal
NOTICE
!
Avoid electrostatic discharge!
The products are equipped with electronic components that you may destroy by electro-
static discharge when you touch. Please observe the safety precautions against electro-
static discharge in accordance with EN 61340-5-1/-3. Pay attention while handling the
products to good grounding of the environment (persons, job and packing).

7.1 DIN-35 Rail

The product is designed for mounting on a DIN-35 rail.
The DIN-rail is centered on the product depth (see
Mounting on the DIN-Rail
Mount the product per EN 60715 by snapping it onto the DIN-rail without tools:
1. Place the product, with the DIN-rail guide, on the top edge of the DIN-rail.
2. Press the product onto the DIN-rail [1] and simultaneously snap the product onto the
snap-in mounting foot (c) [2].
3. To ensure secure mounting on the DIN-rail, install an end stop (e.g., Item No.
249-116) in front of and behind the product (with a block arrangement: on either side
of the products).
If products are snapped on alternately, place separator plates (Item No. 209-191) be-
tween two adjacent clamping units for safe separation.
32 Product manual | Version: 1.0.0
Electronic Circuit Breaker
8 Product
[} 14]).
1.
2.
787-3861/108-020
Figure 16: Assembly