JVC KD-S730 Service Manual page 34

KD-S730
KD-S630
5.While tuning the pickup gear in the arrow
direction as shown in Fig.20, shift the entire
pickup unit.
6.Remove the three screws © retaining the
feed motor assembly and take out this motor
assembly (See Fig.19).
7.While pressing and expanding the spring
section holding the FD screw in the arrow
direction,remove the FD screw and dismount
the pickup unit(See Fig.21).
8.By removing the two screw @ retaining the
pickup unit,dismount the nut push spring plate
and pickup mount nut (See Fig.22).
9.Remove the FD screw from the pickup unit
(See Fig.22).
FD screw
Pickup unit
Fig.21
Feed motor
assembly
Pickup unit
Pickup gear
Feed motor assembly
Fig.20
Nut push , 2
spring &
Pickup
mount unit
Pickup unit
FD screw
Ne