Advertisement
KD-S730
KD-S630
Bracket
fe)
1
as
amid
ne
7 (A mo
[ CD Mechanism Section |
CD mechanism
P.C.board
1.Remove the CD mechanism assembly
(See "Removing the CD mechanism assembly').
2.Remove the three springs @) and ® from behind the
CD mechanism assembly(See Fig.10).
3.Disconnect the flexible wire connected to the
:
connector on the CD mechanism control P.C.board
Loading motor
Fig.11
(See Fig.10).
g:
4.Remove the one screw @) retaining the CD mecha-
nism control P.C.board(See Fig. 11).
5. After disengaging the engagement between the
notch section © and frame,remove the CD mecha-
nism Control P.C .board successively from @ through
to @ in the arrow direction as shown in Fig. 11.
Pick up Flexible wire
be sure to remove the soldering in advance
mechanism
assembly can possibly be
damaged.
CD mechanism
control board
6.Remove the two screws ( retaining the front bracket for
fixing the CD mechanism control P. C. board(See Fig.10 or 13).
Fig.13
2-12
Advertisement
