5.3 Printer Test
Before performing AAS contour cutting, it's recommended to print out a test file to make sure
the AAS II cutting accuracy. Please visit GCC website and go to Download Area to download the
test files.
https://www.gccworld.com/download.php?act=view&id=20
There are two testing files for AASII:
1.
AAS II_X_Y_Offset_Caberation_A4 .eps (A4 size)
2.
AAS II_X_Y_Offset_Caberation_600_600 .eps (Default setting, it is recommended for
testing)
Print out the testing graphic. ( Please use high precision printer)
Load the graphic to RX II series and sent the file to test the cutting job
If there are any adjustments to be made, you can change the offset value by following
the steps:
■ Measure the offset values from the printed line and the actual cutting line.
■ Enter the AAS Offset under MISC function for the values you just measured, then
press Enter
■ Test the cutting again
■ AAS II offset X and Y value is defined as following:
Horizontal line is defined as X and vertical is defined as Y (when facing the cutting
plotter)
Automatic-Aligning System
5-6
RX II series User Manual