Diagnostic Test For Sram And Dram; Diagnostic Test For Lever Sensor - GCC Technologies J5 Series Maintenance Manual

Version : 9.0

5.1.2 Diagnostic Test for SRAM and DRAM

This test provides the ability to diagnose the SRAM and DRAM. If these two components are bad,
replace them. Otherwise the cutting plotter will not work properly.

5.1.3 Diagnostic Test for Lever Sensor

This feature diagnoses the lever sensor. If the sensor is faulty, the cutting plotter cannot sense that the pinch rollers have
been lowered or not. If the lever sensor is down, you will see a lift the lever message on the LCM. If the lever is up, you will
see a lower the lever message on the LCM. You can use the ON/OFF LINE KEY to abort your test when you have finished
the lever sensor test.
Check Lever Sensor
Up/Down
Enter Key
Cancel Key
Display lever
sesor condition messages
Previous/Next Test item
Note that: LCM will display one of following messages
1.Lower The Lever Please CANCEL
2.Lift The Lever Please CANCEL
The first message means that the current lever condition is up
The second message means the lever is down
46