Starting And Ending Loopbacks; Resetting The Unit - Paradyne HotWire 7914 User Manual

Testing

Starting and Ending Loopbacks

Resetting the Unit

7-4
To start or end a local loopback test, enter 4 at the Command prompt.
Command 4
Local Loopback is Enabled!
Command 4
Local Loopback is Disabled!
To start or end a remote loopback test, enter 5 at the Command prompt.
Command 5
Remote Loopback is Enabled!
Command 5
Remote Loopback is Disabled!
Enter R at the Command prompt to reset the board. This is equivalent to cycling
the power.
Command R
Reset will bring the loop down. Are you sure? (y/n)
Command
If "y" is selected, the Main Menu is displayed, the loop goes down, and the Loop
LED blinks until the loop is restored.
Pressing any key other than "y" is interpreted as an "n".
February 1998 7914-A2-GB20-00