Connecting To The Network - Paradyne HotWire 7914 User Manual

Connecting to the Network

7914-A2-GB20-00
Procedure
1. Connect one end of the supplied 14 twisted-pair network cable into the rear
panel DSL jack. Connect the other end to your SDSL network interface.
NOTE:
Do not use a flat VF network cable, as this may severely degrade the
performance of the termination unit. Use only twisted-pair network cable.
2. V.35/V.11-compatible units only: Use either a DB25-to-V.35 adapter cable
(see DB25-to-V.35 Adapter Cable Pin Assignments
assignments) or a cable with DB25 connectors. Connect one end to the
V.35/V.11 socket on the rear panel. Connect the other end to your V.35/V.11
equipment.
V.35/V.11-Compatible Hotwire 7914 – Rear Panel
3. DSX-1-compatible units only: Connect a DSX-1 interface cable into the DS1
jack on the rear panel. Connect the other end to your DSX-1 equipment.
DSL
DSX-1-Compatible Hotwire 7914 – Rear Panel
February 1998
in Appendix B for pin
48 VDC
Installing the Unit
DS1
97-15714
2-3