Testing
Starting and Ending Loopbacks
Resetting the Unit
7-4
To start or end a local loopback test, enter 4 at the Command prompt.
Command
4
Local Loopback is Enabled!
Command
4
Local Loopback is Disabled!
To start or end a remote loopback test, enter 5 at the Command prompt.
Command
5
Remote Loopback is Enabled!
Command
5
Remote Loopback is Disabled!
Enter R at the Command prompt to reset the board. This is equivalent to cycling
the power.
Command
R
Reset will bring the loop down. Are you sure? (y/n)
Command
If "y" is selected, the Main Menu redisplays, the loop goes down, and the Fail
(reset) LED lights.
Pressing any key other than "y" is interpreted as an "n".
September 1997
7915-A2-GB20-20