Table of Contents
Advertisement
Customizing V.35/V.11-Compatible Units
Making Changes from the Terminal Interface
5-2
The Board Configuration menu displays the current board software and hardware
settings. It also allows you to change certain parameters on the board.
This function is affected by the status of the switchpack (DIP switch control)
setting.
When operating in Terminal Mode (the system default) you can make
configuration changes through the terminal menus.
When operating in Switchpack Mode, you can display configuration
parameters using the terminal menus, but any configuration changes must be
made using the switchpacks and jumpers on the board hardware. Refer to
Making Changes in Switchpack Mode
To access the Board Configuration menu, enter 3 at the Main Menu Command
prompt.
Command
3
Board Configuration:
1) SDSL Card Type
SDSL Interface
2) Payload Rate
Timing
SDSL FW Rev
Globespan FW Rev
CP Serial #
–––––––––––––––––––––––––––––––––––––––––––––––––––––––
1–2)
Board Configuration
3)
Switchpack Definitions
?)
Prints Board Configuration and this menu
Q)
Quit
Config
Possible values for each parameter are listed in
Worksheets
, for help in selecting the appropriate configuration options for your
application.
The S4 Switchpack setting is displayed only if the unit is in Switchpack Mode.
February 1998
on page 5-4.
– CP
– V.35
– 1544 Kbps (Unframed)
– Loop
– 1.2
– 1.12
– 085561
Table
5-1. See Appendix A,
7914-A2-GB20-00
Advertisement
Table of Contents
