To Play Only Desired Tracks - Pioneer PD-M407 Operating Instructions Manual

TO PLAY ONLY DESIRED TRACKS/DISCS
Direct Program:
the track being played can be programmed.
1. Press the PROGRAM button to enter the program
mode.
2. To search for a desired track during normal play
back, itis possible to skip to succeeding tracks by
pressing the <4 <q or BR PP! button.
Also, Magazine Hi-Lite Scan function can be used to move
from track to track through the disc.
3. Ifyou wish to program the track currently playing,
press the PROGRAM button while the track is
playing.
® Direct programming is not possible during program
playback.
To check the program contents
(PD-M427 only):
the CHECK button on the remote control unit. The program
contents wil! be displayed in the programmed order.
Inserting a cause in your program can be very useful when
carrying cording. Press the il button on the remote
* For examole, when recording on both sides of a cassette
tape, if you program a pause after the last track to be
recorded on the first side, program playback will pause at
that poi ow you to switch tape sides. To resume
prograrr ck after the player enters pause mode,
press the i button on the remote control unit or »/#
button on the front panel.
NOTES:
° A pause can be programmed only when the program
procedure. is performed under stop mode.
° A pause cannot be programmed at the beginning of a
program (P-01), nor can two pauses be programmed one
after the other :
A pause inserted in a program is counted as one step.
° Ifa pause is programmedas the last step ofa program, the
Player will not enter the pause mode.
To erase a program (PD-M427 only):
During program mode, press the CLEAR butten on the
remote control unit.
The last program step is erased and the contents of the
previous program step are displayed.
NOTE:
Contents of a program can be erased during playback as well.
However tracks preceding the currently playing track cannot
be erased in this way.
To clear ail of the program contents:
A. During stop mode, press the @ button.
B. When the magazine is ejected, the program contents will
be cleared.
To modify the program contents
(PB-M427 only):
1. During program mode, set the player to stop
mode and press the CHECK button onthe remote
control unit so that the program step to be
corrected appears on the display.
2. Enter the new disc number with the DISC
NUMBER (DISC 1-DISC 6) buttons and then
press the <td <q or BR PP button so that the
new track number appears on the display.
3. Press the PROGRAM button.
e Repeat steps 1 through 3 to change other tracks as
desired.
° Ifthe Mea <4 of RB» Bi button is not pressed within
2 seconds when correcting the track number, the
displayed track number is automatically memorized.
V3,