Package Checklist; Tools Required; Related Documents - Paradyne 5030 Installation Instructions Manual

Preparation
Verify that:
The local loop POTS is connected to the POTS/DSL network at the punchdown
block or NID.
New or existing unshielded twisted-pair wiring (CAT3 or better) is used with this
product. The CAT3 wiring must meet EIA/TIA-568 specifications with 24 AWG
(.5 mm) or 26 AWG (.4 mm).

Package Checklist

Verify that your package contains the following:
POTS splitter and housing with closure screw.
Small plastic bag with two 8–15 x 1 Type A combination Phillips/slotted-head
screws and two 1 plastic anchors.

Tools Required

Flat-blade screwdriver to tighten terminal screws
3/8 nut driver to close housing securely
Phillips-head or combination Phillips/slotted-head screwdriver to mount the housing
Drill and 3/16 drill bit to mount the housing in cement or cinder block

Related Documents

For Hotwire RADSL endpoint installation instructions, refer to the appropriate document:
Document Number Document Title
5216-A2-GN10
5246-A2-GN10
5446-A2-GN10
5620-A2-GN10
6371-A2-GN10
Contact your sales or service representative to order additional product documentation.
Paradyne documents are also available on the World Wide Web at
www.paradyne.com. Select Library
Hotwire 5216 RTU Customer Premises Installation Instructions
Hotwire 5246 RTU Customer Premises Installation Instructions
Hotwire 5446 RTU Customer Premises Installation Instructions
Hotwire 5620 RTU Customer Premises Installation Instructions
Hotwire 6371 Rate Adaptive DSL Router Installation Instructions
Technical Manuals.
2