Table of Contents
Advertisement
User defined files
You can use a frequency list from a user defined file
(.chplan) to specify a user defined channel plan.
Load the user defined file in [Channel Plan Adviser], and
determine frequencies while referring to the signal
environment information from scan results, etc.
To create user defined files
Use a text editor such as Notepad to create the file. Be sure
to specify ".chplan" as the file extension.
Define one frequency per row.
Note
When the "#" sign is entered, text that is entered after the
"#" in that row will be considered comments.
Example: When defining a 12-ch plan that connects group
D1 of TV42-45 (US Model) for simultaneous operation.
# User define Channel Plan
# TV42-45 / D1 Group
638.250 # 42-02
638.750 # 42-06
639.250 # 42-10
639.750 # 42-14
640.250 # 42-18
640.750 # 42-22
641.250 # 42-26
641.750 # 42-30
642.250 # 42-34
642.750 # 42-38
643.250 # 42-42
643.750 # 42-46
Note
Only the frequencies indicated in the frequency list
supplied with the receiver can be used.
[Omit IP address list] Window
When you register an IP address in this list, the IP address
is excluded from automatic detection and will not appear
in the device list window.
Use this function when multiple systems are connected on
the same subnet, and you do not want to display the
devices from other systems.
To display the [Omit IP address list] window, select
[Device] menu > [Omit IP address list].
The [Omit IP address list] command can only be used in
offline mode.
Adding an IP address to the list for
exclusion from automatic detection
Click [Add], enter the IP address you wish to exclude from
detection, and then click [Close].
Changing an IP address on the list
Click the IP address you wish to change, click [Edit], make
the desired changes, and then click [Close].
Removing an IP address from the list
Click the IP address you wish to delete, click [Delete], and
then click [Close].
[Setting lock] Window
You can prohibit the modification of receiver and
transmitter settings from Wireless Studio. An
administrator password must be configured to use this
function.
When setting modification is prohibited (i.e., locked), you
can temporarily enable setting changes by clicking the lock
release buttons in the [Property] window and the [Property
List] tab, and then entering the administrator password.
Locking settings
1
Select the [Setting lock] checkbox.
52
Advertisement
Table of Contents
