Sony DWR-R02DN User Manual page 22

Wireless studio
Hide thumbs Also See for DWR-R02DN:
Table of Contents

Advertisement

Note
You can change the [Receiver Model] and [Transmitter
Type] settings when editing settings in offline mode.
However, if you specify a setting that differs from the
actual setting of the device, an inconsistency will occur
when you apply the setting using the [Load settings]
function. The cells for these [Receiver Model] and
[Transmitter Type] settings will be displayed in yellow.
Make sure to use the actual model name and type of the
device when changing the [Receiver Model] and
[Transmitter Type] settings.
Opening files and applying settings
1
Remove the check mark next to [Online monitoring
and control] in the [Device] menu.
The system enters offline mode.
2
Select [File] menu > [Open].
3
Select the previously saved file, and click [OK].
The information stored in the file is displayed on the
Wireless Studio screen.
Edit the settings here if necessary.
4
Select [All Receiver's settings], [All Receiver's and
All Transmitter's settings], or [Select Receiver's and
Transmitter's settings] from [Device] menu > [Load
settings].
The settings are applied to the devices. The devices to
which the settings are applied will depend on the
option you selected.
If [All Receiver's settings] is selected
The settings are applied to all the receivers that appear
in the device list.
If [All Receiver's and All Transmitter's
settings] is selected
The settings are applied to all the receivers that appear
in the device list and their paired transmitters.
If [Select Receiver's and Transmitter's
settings] is selected
The [Load settings] window. The settings are applied
to the digital wireless receivers and transmitters
selected in the [Load settings] window.
If for some reason the stored values could not be
applied to a setting item, the cell for that item will be
displayed in yellow in the [Property List] tab. In such
cases, make sure to check the status and setting values
of the devices.
Notes
• The following conditions must be met for the settings to
be applied to the receivers.
- The IP addresses of the receivers that appear in the
device list must be the actual IP addresses of the units.
- The [Receiver Model] settings must be the actual
models of the receivers.
• The following conditions must be met for the settings to
be applied to the transmitters.
- The transmitters are paired.
- The [Transmitter Type] settings must be the actual
types of the paired transmitters.
- The transmitters are within the wireless remote control
service area.
Using individual settings files for
individual devices
Wireless Studio allows you to save individual settings files
for individual devices. You can recall previous settings by
loading settings that were previously saved to a file and
applying them to a device.
Note
Only the setting values of a device are stored to the file.
22

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dwr-r01dDwr-r02d

Table of Contents