[Simple Status Viewer] Tab - Sony DWR-R02DN User Manual

Wireless studio

Hide thumbs Also See for DWR-R02DN:

Operating instructions manual (42 pages)

Table Of Contents

Table of Contents

a Target receiver selection

Allows you to select the receivers that will perform

scanning for each frequency band. Scanning will not be

performed for frequency bands for which [Do not scan] is

selected.

When the [Reflect recommended GP/CH] checkbox is

selected in the [Channel Plan Adviser] window and you

apply the settings to the [Spectrum Analyzer] tab, the

receivers that will perform scanning will be selected

automatically.

In such cases, if multiple receivers that correspond to a

frequency band exist, the receiver with the earliest IP

address will be selected. However, if a DWR-R02DN is

included, it will be selected regardless of its IP address.

Scanning is performed on CH1 of each receiver.

The operations will vary depending on the model of the

receiver.

DWR-R01D/R02D

To receive the transmitter signal on CH2, configure the

same band setting as that for CH1 scanning. If different

bands are selected for CH1 and CH2, audio interruption

will occur on CH2.

DWR-R02DN

To receive the transmitter signal on CH2, configure the

same band block setting as that for CH1 scanning. If

different band blocks are selected for CH1 and CH2, audio

interruption will occur on CH2.

• Example for North American models:

To prevent audio interruption when the frequency band

setting for CH2 is set to TV14-17, set the frequency band

that will be used for CH1 scanning to a band that belongs

to band block U14(TV14-25) (TV14-17, TV18-21, or

TV22-25).

Band block

U14(TV14-25)

U30(TV30-41)

U42(TV42-51)

• Example for European models:

To prevent audio interruption when the frequency band

setting for CH2 is set to TV21-23, set the frequency band

that will be used for CH1 scanning to a band that belongs

to band block CE21(TV21-29) (TV21-23, TV24-26, or

TV27-29).

Band

TV14-17

TV18-21

TV22-25

TV30-33

TV34-36

TV38-41

TV42-45

TV46-49

TV50-51

Band block

CE21(TV21-29)

CE33(TV33-40)

CE42(TV42-50)

b Scan count setting

Continuous scan: After scanning starts, it is performed

continuously until the [Stop scan] button is clicked.

Specified count scan: After scanning starts, scanning is

performed the number of times specified in [Repeat

count].

c Other settings

Frequency Interval: Select from 125 kHz or 25 kHz as

the interval at which to scan.

[Peak hold]

Select whether to hold and display scanning result values

for each frequency.

ON: The highest RF level of a set of scanning sessions

(during [Continuous scan] or when [Repeat count] is set to

2 or higher for [Specified count scan]) is displayed in the

graph.

OFF: The most recent RF level of a set of scanning

sessions (during [Continuous scan] or when [Repeat

count] is set to 2 or higher for [Specified count scan]) is

displayed in the graph.

d Close button

Closes the [Scan parameter] window.