Table of Contents
Advertisement
45OW
1OOOW
Average:
1OOOW
Average: 500W
POWER CONSUMPTION
Peak:
Electric4 Characteristics
BLOWER MOTOR
Operating speed: 2650 rpm
Airflow: 28-30 cfm
Electrical Characteristics
BLOWER MOTOR
Operating speed: 3 150 rpm
Airflow: 28-30 cfm
POWER CONSUMPTION
Peak:
Ordinary equipment, Continuous operation
CERTIFICATIONS
UL 544, CSA C22.2 No. 125, IEC 601-1, IEC
601-l-2, EN55014, AS 3200.1990
CLASSIFICATION
Classified under IEC 601-l Guidelines as Class 1,
Type BE Ordinary equipment, Continuous operation
ALARh4
SYSTEM
Over-heat: flashing red light with audible alarm;
heater shuts down
Safety System
THERMOSTAT
Independent bulb and capillary
OVERCURRENT PROTECTION
Dual fused input lines
ALARM SYSTEM
Over-heat: flashing red light with audible alarm;
heater shuts down
CERTIFICATIONS
UL 544, CSA C22.2 No. 125, IEC 601-1, IEC
601-l-2, EN55014, AS 3200.1990
CLASSIFICATION
Classified under IEC 601-l Guidelines as Class I,
Type BE
5.4"F
Safety System
THERMOSTAT
Independent bulb and capillary
OVERCURRENT PROTECTION
Dual fused input lines
+
i 3°C
89.6"
5.4"F
LOW: 32"
*
i 3°C
100.4"
5.4"F
MED: 38"
*
* 3°C
109.4"
5.4"F
Average temperatures at the end of the hose,
assuming the back pressure of an Augustine
Medical, Inc. warming blanket, or an Augustine
Medical, Inc. temperature test unit:
HIGH: 43"
r
* 3°C
89.6"
5.4"F
LOW: 32"
i
f 3°C
100.4"
5.4"F
MED: 38"
+
i 3°C
109.4"
t e listed temperatures.
Average temperatures at the end of the hose,
assuming the back pressure of an Augustine
Medical, Inc. warming blanket, or an Augustine
Medical, Inc. temperature test unit:
HIGH: 43"
the
patient are approxi-
a
rnateb 2°C lower than
t e Listed temperatures.
OPERATING TEMPERATURES
Air temperatures reacbin
the
patient are approxi-
a
matel,, 2°C lower than
sets
OPERATING TEMPERATURES
Air temperatures reacbin
(37.7"C)
-17
BTUs (average)
SYSTEM TIME TO
100°F
sets
HEAT GENERATED
1800
(37.7"C)
-35
BTUs (average)
SYSTEM TIME TO
100°F
connolled using a thermocouple sensor
HEAT GENERATED
1800
a\_
TEMPERATURE CONTROL
Electronically
me-P
E&ctronically controlled using a thermocouple sensor
Temperature Characteristics
0.2pM level
RECOMMENDED FILTER CHANGE
Every 6 months or 500 hours of use
RECOMMENDED FILTER CHANGE
Every 6 months or 500 hours of use
Temperature Characteristics
TEMPERATURE CONTROL
0.2pM level
FILTRATION SYSTEM
241a fluid warming system
FILTRATION SYSTEM
l@ fluid warming system
Detachable, flexible, washable; compatible with
Bair Hugger
53
decibels
HOSE
HOSE
Detachable, flexible, washable; compatible with
Bair Hugger 24
MOUNTING
Supplied with swivel casters; floor use only
MOUNTING
IV pole clamp, bed rail hook with safety strap;
can be placed on hard surface
RELATIVE NOISE LEVEL
RELATIVE NOISE LEVEL
52 decibels
Advertisement
Table of Contents
