Isolation Switch - Bair Hugger 505 Operator's Manual

the receptacle clear of obstructions. the area around
the
wall receptacle. Keep
cordfiom the power the power source, remove unitfiom the Model 505
505 unit does not have an isolation switch.
CAUTION: To disconnect
500/OR,E warming units. The isolation switch must be in the ON position
before the warming unit will operate. The Model
500/OR and
500/OR,E units
Isolation Switch
The isolation switch allows you to disconnect the warming unit from the power source without
removing the power cord from the wall receptacle. The isolation switch is located on the back of
Model
500/OR and
/
Figure M. Isolation Switch on Model
a,
241@ fluid warming, attaches by inserting the flange end at a 45" angle in the grooved blower outlet,
then by "snapping" the hose into place.
Press the white tab on the blower outlet to release the hose.
When storing the Model 505 unit, insert the hose clip tab in the hanger slot near the blower outlet.
W&ng Unit Hose
The Model 505 unit has a unique "snap-fit" hose. This extended length, swivel hose, adapted for
,e-------
Press this tab
Figure L. Storing the Model 505 unit hose
Attaching and Storing the Model 505
Figure K. Attaching the Model 505
unit hose