Paradyne COMSPHERE 3810 Quick Reference Manual page 12

If the modem is to communicate with an installed SDCP, install the modem as
described above and perform the following steps:
1. Press the
Select
entry.
2. Press the F1 (") or F2 ( ) key until the carrier number you want appears on the
LCD.
3. Press the key to position the cursor on the slot selection entry.
4. Press the F1 (") or F2 ( ) key until the slot number (1–16) you want appears on
the LCD.
5. Press the
Select
selected modem.
— The LCD displays the Top-Level menu for the selected modem. In addition,
the Front Panel LED on the modem's faceplate and the OK LED on the SDCP
light.
6. Once you have determined that the modem is installed properly and completed its
power-up self-test, rotate the circuit pack lock until it covers the faceplate latch.
This prevents the modem from accidently being removed once it is installed in a
carrier.
CLOSED
(LOCKED)
OPEN
(UNLOCKED)
key on the SDCP. The cursor appears in the carrier selection
key to place the SDCP in direct communication with the
CIRCUIT
PACK
LOCK
LATCH
10
CIRCUIT
CARD
GUIDE
CIRCUIT
CARD
GUIDE
495-11985a-03