Paradyne COMSPHERE
3610 Quick Reference Manual page 32

Canada – Notice to Users of the Canadian Telephone Network
The Canadian Department of Communications has certified that this equipment meets
certain telecommunications network protective, operational, and safety requirements.
The Department does not guarantee that the equipment will operate to the user's
satisfaction.
Before installation, verify connectivity of this equipment to the local telecommunications
company's facilities. The equipment must be connected by an acceptable method. In
some cases, the telecommunications company's inside wiring associated with
single-line individual service may be extended with a certified connector assembly
(telephone connection cord). The customer should be aware that compliance with the
above conditions may not prevent degradation of service in some situations.
If you experience difficulty with this equipment and require service, refer to Warranty,
Sales, Service, and Training Information in the front of this document.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility. Any repairs or alterations made by the user to this equipment, or
equipment malfunctions, may cause the telecommunications company to ask you to
disconnect the equipment.
Users should ensure that the electrical ground connections of the power utility,
telephone lines and internal metallic water pipe system, if present, are connected
together for protection. This precaution may be particularly important in rural areas.
CAUTION:
Users should not attempt to make such connections themselves, but should
contact the appropriate electric inspection authority, or an electrician, as
appropriate.
The load number (LN) is labeled on the equipment. The LN denotes the percentage of
the total load to be connected to a telephone loop used by this equipment. To prevent
an overload, the total of the LNs of all devices attached to the loop may not exceed 100.
The LN also specifies the appropriate ringing type (A or B), if applicable. For example,
LN = 20A designates a load number of 20 and an A type ringer.
If you experience trouble with this equipment, please contact your sales or service
representative (as appropriate) for repair or warranty information. If the trouble is
causing harm to the telephone network, the telephone company may request that you
remove the equipment from the network until the problem is resolved.
*3610-A2-GL11-20*
*3610–A2–GL11–20*
32